Search results

Hi, Im looking to install an L67 into my early 4L60 trans (not electronic) I know that the flexplates on the L67 are different to the standard ecotec, a different balance and that the L67 also uses a larger diameter torque convertor My question is:- will the standard T/C bolt up to the L67...

Hi brains trust, i am getting high knock counts with the VP V6 ecu. knock counts are a steady 195 - 200 across ALL RPM and Load ranges, including at idle and overrun? This then causes the ECU to give a constant 12 deg advance reduction any suggestions re what may be causing this greatly...

hi brains trust. my V6 has a siezed knock sensor, outer section . inner section, that has the nut and plug etc turns in the outer. any suggestions on removal appreciated

Hi, have finally decided to replace my 808 loom on my ecotec with an ecotec loom. My current wiring is in 2 parts, 1/ lwr engine loom and relays which controls starter alternator fuel pump etc. 2/ engine top loom which plugs into the sensors and ecu unit and injectors. Is any of this...

hi, im running an ecotec with the 808 ecu. previous motor ran very well no issues, this replacement motor?? !/ ecotec with vp loom and sensors. Runs well when cold, performance is great, BUT, after reaches operating temperature power drops dramatically? at no time does it misfire or bad...

Hi brains trust, i am using a TH700 type trans with a manual TCC switch for the lockup wired through the 4th gear etc. My problem is that it all works fine when the box is cold, but stops working when box is hot. Replaced the solenoid at recent service as old unit had slight cracking any ideas??

Hi, i have a VZ with engine code H7A, which has died can i fit one with code H7L? or what do i have to change to make work? im assuming that if i stay with all original sensors and T/B, ECU etc it should be OK?

Hi i have a missfire that occurs under load when at operating temp when cold goes as normal but as soon as its at operating temp breaks down under load, generally looses power and responsiveness so far have changed:- plugs leads coilpacks and ig plate still no change in drivability...

hi guys, looking at the above conversion but would like to keep the VP 808 ecu? any info please rgds

hi, looking for some help recently replaced the old buick with the ecotec(running 808 ecu) engine idles fine accelerates OK, runs the 700 auto but has extreme vibration at ~ 2000-2300 rpm in neutral the motor vibrates ~ 20mm higher revs all OK this coincides with a 'barking'...

hi, changing out my old vp buick v6 with a vx ecotec using the vp sensors and ecu need map tune to suit the ecotec regards

hi, recently inherited the above and having some wiring issues the engine check light was never wired in during the conversion and i wish to do so now todate i have done the following 1/ using a suitable globe fitted into dash (not using any of the existing prnted circuits) 2/ taken...