Neal
New Member
- Joined
- Jan 2, 2012
- Messages
- 17
- Reaction score
- 9
- Points
- 3
- Members Ride
- 2006 VZ Adventra Lx6
I have a VZ Adventra Lx6 that whenever the coolant fill cap is removed when cold, the level is always below the neck and takes 200mL - 300mL to refill to the brim. The level on the overflow tank dipstick is if anything a little high.
The engine runs perfectly and temp is rarely above ~25% on the gauge, and I've recently had the heater tap replaced, together with the water pump and thermostat while the transmission was out.
Pressure test OK.
I'm wondering if the coolant level at the screw on/off fill cap is supposed to be about 40mm below the brim?
Edit: I'm looking for a new cap, but retailers such as Supercheap specify one with 140 kPa, where the one currently on the Adventra is 125 kPa.
Which is correct ??
Any advice or ideas very welcome
The engine runs perfectly and temp is rarely above ~25% on the gauge, and I've recently had the heater tap replaced, together with the water pump and thermostat while the transmission was out.
Pressure test OK.
I'm wondering if the coolant level at the screw on/off fill cap is supposed to be about 40mm below the brim?
Edit: I'm looking for a new cap, but retailers such as Supercheap specify one with 140 kPa, where the one currently on the Adventra is 125 kPa.
Which is correct ??
Any advice or ideas very welcome
Last edited: