Recent content by scozz

just a thought, but i've always believed in running a larger amp than the speaker - eg 300w speaker & 400w amp (just guessing figures at the moment). Reasons being, you want the speaker to die before the amp - if the amp starts to fail (due to it being pushed) all you'll start to notice is...

It sounds like you've wired the 6x9's out of phase to each other. For the best set up, you'll have to phase up the front and the rear then make sure the sub is in phase with the main speakers - refer to the wiring diagram of your head deck for the correct speaker wiring (front/rear). pos to pos...

With engine running, put your foot on the brake and put it in drive - does it vibrate? Then put it in reverse (foot still on the brake), then engine will kick the opposite way, Is it vibrating? I had this problem with my VN - It was the engine mounts.

QUOTE (Gobbles @ Apr 17 2004, 12:41 AM) .....but im not sure about any power increases though..it would also make the engine bay look a bit better I'd question if it would make the engine bay look better. Why go to the trouble for very little increase? Trying to picture what it would look...

2 x 4ohm speakers in parallel will give you 2 ohms. ohms law v=IxR I=V/R R=V/I Make sure your speaker cables are a high amperage rating. I've used 240v cables in the past. 2core + earth (it's cheaper than 2core) That was for a 100metre run aswell @...

This is what I did with mine. VS Automatic - Bucket Seat Model. Remove the gear selector cover plate Remove 3 screws from the black surround panel (at the bottom) then remove the surround panel. Take note of L.E.D connection and disconnect. Remove screw that holds in the heater control...

QUOTE (jafo @ Mar 23 2004, 08:51 PM) Sansui SM-A1400FX 4-Channel Amplifier and no the 15" cone did not come from jaycar that was a friends mate who had that. the amp is 80watt per channel i think but running two channels on the sub I helped jafo with his sub setup - The 15inch speaker is...

I'm just saying why do half the job - don't be lazy, screw the unit in. You can cut silicone. Also think about the next person who may want to change the head unit!

after buying the wood, screws, glue, terminals, dampening material, speaker carpet - The time and effort to design, cut and assemble - It's a lot easier to just buy something that has been designed for a specific purpose. I've built and installed cinema subs using 15 - 18 inch speakers and...

10" Sub box - 25L - Ported $39.50 @ Jaycar 12" Sub Box - 35L - Ported $50.00 @ Jaycar 15" Sub Box - 45L - Ported $59.50 @ Jaycar Why Build when it's fairly cheap to buy?

silicone??? you don't need alot of pressure to break silicone! why not just use play-doh?

Try Cleaning the Throttle Body and / or check for vacuum leaks at the throttle body, vacuum hoses and inlet manifold.

I think it's your computer jafo! I mean, I use it a lot and it give me the shits!!!! then I found the power button

Standard Fuel tank 63L (i think) - the fuel pump is inside. I've been told that the larger tank has a pump outside of the tank. not sure if there's also one inside.

i had the same prob in the VN. It was the o2 sensor.