Thisted89
New Member
- Joined
- Feb 24, 2024
- Messages
- 4
- Reaction score
- 5
- Points
- 3
- Age
- 34
- Location
- Queensland
- Members Ride
- VS Executive II
Hi everyone,
I've just joined the site. I've been working on a VS model for Blender for a few months on and off. It isn't 100% complete yet, but I wanted to upload it to fellow Commodore lovers.
I'm a beginner at Blender and this is only my fourth overall 3D project, so the topology of the model mesh is quite horrendous. No blueprints or vectors exist for the VR/VS, so I had to use ones from the Opel Senator B and use photos to replace the front and rear to get semi-accurate dimensions.
This means that the car cannot be used in games and only serves the same purpose as a die-cast model... just to sit and be looked at. When I get round to adding the interior and other exterior components that the model lacks, I'll upload it here.
I've just joined the site. I've been working on a VS model for Blender for a few months on and off. It isn't 100% complete yet, but I wanted to upload it to fellow Commodore lovers.
I'm a beginner at Blender and this is only my fourth overall 3D project, so the topology of the model mesh is quite horrendous. No blueprints or vectors exist for the VR/VS, so I had to use ones from the Opel Senator B and use photos to replace the front and rear to get semi-accurate dimensions.
This means that the car cannot be used in games and only serves the same purpose as a die-cast model... just to sit and be looked at. When I get round to adding the interior and other exterior components that the model lacks, I'll upload it here.
Attachments
Last edited: