I cut an access hole under the seat to get to the fuel pump, the connection looks good. It had no burnt pins like the other picture in this thread.
I'm thinking its the battery causing the code, the voltage drops to 9.8v on startup.
It was bought privately, so no warranty.
In that case I'll look into getting to the connector, if the tank needs dropping ill just cut a hole and then plate it up when I'm done. I'm sure it won't be the last time the sender will need accessing
Ok thanks for info, ill give holden a shot. Not sure what they'll say as I've just purchased the car, a 2013 model with 140,000km.
All of the service history is stamped by holden though, worth a shot.
Its also a wagon, is the fuel pump access any easier on a wagon?
My VF Calais is displaying fault code P129D-00 "fuel pump driver control module Ignition on / start switch switch voltage low.
The remote start does not work, If I clear this code and then turn the car off without starting it, it will allow the car to crank for a second via remote start,, but...
I don't think the -22 is a location identifier, when the left front sensors were installed in the wrong positions I was getting "B0955-3A" & "B096C-3A". These 3A codes relate to incorrect component installed, according to the service manual.
After switching there positions the 3A code has...
I've just bought a VF calais
The parking sensors where not functioning when I bought it, it was displaying "park assist temporarily unavailable" when I put it in reverse.
I scanned the codes, 2 codes were logged, both saying that the 2 front left and front left middle had the "incorrect...
I've got a series 1 vf calais
The front lower seat base keeps releasing where it wraps around the front of the seat
Apparently this was a common problem and lots where replaced under warranty
Has anybody got a fox for it? When I search I see people talking about metal clips that where fitted...
Thanks for the help, I got them free. To any body else trying to free them up, the barrel spins inside the plastic trim / housing so lube up between the barrel and the plastic housing as this is were it jams up
I've got a VF wagon with genuine roof racks fitted
I have the correct key but the locks for the plastic covers won't turn, I doubt they've been removed since the car was new
I've tried putting some wd40 in the barrel but it didn't work
Any other ideas on removing them without smashing off the...
I've just fitted some diffilipo extractors to my VZ, the crank angle sensor wireing is very close to them.
I've covered the wireing in heat insulation thats is rated to 537°c continuous radiant heat or 260°c direct heat, ive also secured the wiring to the block in the area of the extractor so...
ITEM: vn calais
LOCATION:
CONDITION: Used
PRICE: everything cheap, everything has to
PAYMENT OPTIONS: cash
CONTACT DETAILS:
OTHER INFO: all parts are avalible apart from the engine and gearbox, the diff has 4.11's and a lockrite lokka rebuilt less than 5000km ago, it has a 3" defillipo...